Hauteur Machine Ã Laver

Mom drain to wash?

Hello beua3

In my measurement guide, it is recommended that the cylinder head be between 60 and 90 cm from the floor.

So I think keeping your measurements on a strong 6-inch pedestal should work.

Here is the answer to your question.

Additional information

We always bend in half to put clothes behind mom

And if the height allows, it is better to increase the measurement at the same time

Even if it's a mother's window, you don't have to go up until you reach the control console.

The higher, the lower the drain pipe will ask you

And you don't need Michelle C to replace the dehydrated blades, which I think the 1M50 should give the world its potential and won't last long.

enock

80 cm is very important for the work of the sword in its initial stage. You run the risk of falling into the so-called starting zone from zero to over 100,000: your sword works, but very little or nothing is empty.

As Ellen B said, if your mother has windows, you can raise your solid mother (maybe solid) to reduce the distance and make it easier to use.

BSR about 60 60.70 cm

Goodbye

No need to lift, the drain blade can lift up to one and a half meters to use water. Make sure you keep air at the end to avoid hypnosis.

Hauteur Machine Ã Laver

That's what I did when it came to me. Dimensions and grooves above 2m20. I installed a PE relay (old PE to rinse the mother's duct) at a medium height. Parallel to the input P relay and the corn tube on the electrical connection, both scales start at the same time, they work without any difficulty.