Water Heater High Temperature Shutdown

My Tourbillon n40t61343 blinks 4 times the temperature. I attach. Is the water cold?

update

I couldn't move much, so I disconnected all the connectors I was able to disconnect and reconnect. But still four flashes, the water is always cold ... This model surpasses the average temperature of 4 flashes. All I said was that I didn't know what to do to collect the water.

Thanks everyone for your comments. I cleaned the filter, it's impossible. = (If the water heater is blinking, it also means that the temperature control box has stopped working and needs to be replaced. If you have a natural gas water heater and it blinks four times) , Then clean the first one. If not, work, it's time to replace the gas control box.

4 High temperature flashing / shutdown is usually caused by gas valve / thermostat malfunction on TSE models. Check if it's still under warranty or if not repair it ... get some deals. The gas valve becomes 220.00. You can also check if the gas pressure is too low ... if you are not sure ... or if the air inlet port under the refrigerator is closed. I have a device that shuts off the screen due to dust around it and clearing the screen solves the problem by not turning on the controller ... usually something as simple as not enough Air flow causes the problem.

Gas water heaters require a small amount of air to supply air to the burners, and newer models may have screens or filters to prevent dust from entering the burner area, which electronic components over time Can prevent or contaminate. The screen or filter can be filled with dust because the air flow is dirty and it can interfere with the operation of the burner or pilot light ... if there is no air flow.

Operating instructions with information on the meaning and optimization of Flash ... Page 28

Troubleshooting Whirlpool Water Heater

Whirlpool gas water heater

The temperature has exceeded the limit, but the water is cold, which means your thermistor is open and your controller is not showing the correct temperature.

Water Heater High Temperature Shutdown

Just guessing, but try to break it down for a while. This allows all sensors to be reset.

Gossip Craze Report

Water Heater High Temperature Shutdown